ATS 021

ABB

Write a Review
$791.88
ABB, AUTOMATIC TRANSFER SWITCH- ATS021 - WITHOUT DIALOGUE FOR CONTROLLER ON MULTI VOLTAGE ARC-FLASH PROTECTION Multi-function logic to meet all requirements • Standard switching logic allows monitoring of the normal and emergency line, sending commands to the generator and controlling that the circuit-breakers have been switched • Management of both the two non–priority lines (ATS021, ATS022); • Management of a third bus-tie circuit-breaker (ATS022); • Management of non-priority load disconnection. No auxiliary power supply required. The new ATS family is designed to work without an auxiliary power supply. An auxiliary power supply is only required when Modbus RS485 communication is used or in networks with 16 2/3 Hz rated frequency. Compliance with IEC and EN 60947 Standards Compliance with the IEC and EN 60947 Standards allows the new ATS family to provide the quality and safety needed for all requirements Compatibility with ABB circuit-breakers and switch-disconnectors The ATS family can be used with ABB SACE Tmax (XT1... XT4, T3...T7) and Emax (X1, E1...E6) series of circuit-breakers and switch-disconnectors, fitting into a complete and coordinated system. Advanced communication interface ATS022 is equipped with a communication unit which allows integration with the supervision systems via Modbus RS485. Furthermore, ATS022 is fitted with a graphic display which makes parameter configuration and display extremely simple. Applications The ATS family is particularly suited to use in all emergency power supply systems where a solution which is simple to use, reliable and rapid to install is required. Below are some of the main applications of ATS: • Power supply for UPS units; • Operating theatres and primary hospital services; • Emergency power supplies for civil building, hotels and airports; • Data banks and telecommunication systems; • Power supply of industrial line for continuous Line-generator If the main network goes down, the ATS021 and ATS022 devices allow management of switching over to the emergency line fitted with a GenSet system. Line-line If the main network goes down, the ATS021 and ATS022 devices allow switching to a second line used as a reserve line. ATS022 allows you to select which of the two lines available is to be the priority line. Management of non-priority loads by means of a bus-tie Should the main network go down, the ATS022 device allows you to switch to a second line used as a reserve line, disconnecting the non-priority loads (NPL) shunted from the main busbar. Management of two independent power supply lines separated by a bus-tie If one of the two power supply lines goes down, the available line supplies both the load side sections by means of the bus-tie (ATS022). Management of the non-priority loads on the outgoing line If the main network goes down, the ATS022 device allows switching to a second line used as the reserve line, disconnecting the non-priority loads (NPL) by means of a bus-tie AUXILIARY POWER SUPPLY-NOT REQUIRED MAX 480 VAC 50,60HZ DOOR MOINTING/DIN RAIL MOUNTING OPERATING MODE-AUTO/MANUAL FEATURES- GENERATOR START-UP BUS-TIE NO-PRIOTITY LINE PRIORITY LINE SELECTION ALSO FEATURES- GENERATOR TEST MODE ABB, AUTOMATIC TRANSFER SWITCH, ATS,EXCO, HURRICANE, GENERATOR, PREPAREDNESS
SKU:
ATS021
UPC:
8015644682033
Condition:
New
Shipping:
Calculated at Checkout
Adding to cart… The item has been added
GET QUOTE
Quick Order